Bently Nevada 330180-X1-00 145004-95 3300 XL Series Proximitor Sensor

FAQ

Q1: What is the Bently Nevada 330180‑X1‑00 (145004‑95) used for?
A1: It is a proximitor sensor module used to condition raw signals from eddy‑current proximity probes into a standardized analog output for vibration and shaft displacement monitoring.

Q2: What does the internal reference 145004‑95 indicate?
A2: It is a manufacturer internal configuration and calibration identifier for this specific proximitor variant.

Q3: Which proximity probes are compatible with this sensor?
A3: It supports both 5 mm and 8 mm diameter proximity probes from the Bently Nevada 3300 and 3300 XL Series.

Q4: What type of output signal does this proximitor provide?
A4: It provides a 4‑20 mA analog signal proportional to the measured gap/displacement.

Q5: What power supply does this sensor require?
A5: It typically operates on a 24 V DC nominal supply.

Q6: What temperature range can this sensor operate in?
A6: It is designed to operate reliably in environments from approximately −40 °C to +85 °C.

Q7: Is additional equipment required to use this proximitor?
A7: Yes — compatible proximity probes, extension cables (if needed), and monitoring or data acquisition electronics are required for a complete measurement system.

Q8: Where is this proximitor sensor typically installed?
A8: It is usually mounted on a panel or DIN rail inside a control cabinet as part of a machinery protection or condition monitoring system.

330180-X1-00 Bently Nevada

We will use wear-resistant cartons to seal the boxes, and take photos for your confirmation before sealing. We will pack the boxes only after confirmation.

For express delivery, we will use DHL, UPS, TNT, FedEx and EMS.

Please rest assured that we have a deep cooperation with express delivery companies and can ensure that your goods are delivered to you in good condition.