GE IC660BBA104 Genius Analog I/O Block

FAQ

Q1: How many analog signals does the IC660BBA104 support?
A1: It supports 4 analog current inputs and 2 analog current outputs, operating on 4–20 mA loops.

Q2: Is user calibration required?
A2: No, the module is factory-calibrated and requires no user calibration.

Q3: Are the inputs and outputs isolated?
A3: Yes, all input channels are isolated from each other and from the outputs; isolation is rated at 1500V RMS.

Q4: Is hot-swapping supported?
A4: Electronics can be replaced without rewiring, but power must be removed to prevent shock hazard.

Q5: What is the module’s input voltage range?
A5: AC input is 98–132 VAC (47–63 Hz); DC input is 105–145 VDC.

Q6: Does the module support diagnostics?
A6: Yes, it supports diagnostics such as open wire, overrange, underrange, high/low alarms, and output feedback errors.

Q7: What configuration tools are supported?
A7: A Hand-held Monitor (IC66*HHM501E v3.7 or later) is required for configuration.

Q8: Are termination resistors required?
A8: Yes, when installed at the ends of the serial bus, a termination resistor should be installed across Serial 1 and Serial 2 terminals.

GE Genius Analog I/O Block IC660BBA104

We will use wear-resistant cartons to seal the boxes, and take photos for your confirmation before sealing. We will pack the boxes only after confirmation.

For express delivery, we will use DHL, UPS, TNT, FedEx and EMS.

Please rest assured that we have a deep cooperation with express delivery companies and can ensure that your goods are delivered to you in good condition.