GE IC694DSM324 PACSystems RX3i Digital Servo Module

Frequently Asked Questions (FAQ)

Q1: How many digital servos can the IC694DSM324 control?
A1: It can control up to four αi or βi-series digital servos.

Q2: What programming software is required for the DSM324?
A2: Proficy Machine Edition, Logic Developer – PLC version 5.0 SP2 or higher is required.

Q3: Does the module support external absolute encoders?
A3: No, the DSM324 only supports incremental encoders. Absolute mode is not supported.

Q4: What happens if the servo is re-enabled after an amplifier E-Stop?
A4: The servo may jump unexpectedly. To prevent this, cycle the 24V control power on the amplifier before re-enabling.

Q5: Can I use this module with Logicmaster 90 or VersaPro?
A5: No, these programming tools are not compatible with the DSM324 module.

Q6: Is the follower function disabled by the ABORT command?
A6: No, the ABORT %Q bit does not disable the follower. You must turn off the Enable Follower %Q bit to stop follower motion.

Q7: Is it possible to jog beyond software EOT limits?
A7: Yes, under specific configurations (if limits are too close), jogging may exceed software EOT boundaries.

Q8: What should I do before wiring or replacing the module in hazardous locations?
A8: Ensure power is switched off to avoid explosion hazards.

Digital Servo Module GE IC694DSM324 PACSystems RX3i

We will use wear-resistant cartons to seal the boxes, and take photos for your confirmation before sealing. We will pack the boxes only after confirmation.

For express delivery, we will use DHL, UPS, TNT, FedEx and EMS.

Please rest assured that we have a deep cooperation with express delivery companies and can ensure that your goods are delivered to you in good condition.